Instruction manual

SM425 INSTRUCTION MANUAL INTRODUCTION
viii 42500001 REV A
NOTICE
• Specification check.
When the instrument arrives, unpack with care. Verify the instrument has not been damaged during
shipment. Verify the specification matched the order and required accessories are not missing.
Specifications can be checked by the model code on the nameplate. Refer to Section 0
“Specifications: for the list of model codes.
• Details on operation parameters
When the SM425 Separate type Oxygen Analyzer arrives at the user site, it will operate based on the
operation parameters (initial data) set at the factory.
Ensure this configuration is suitable for the application before any testing is performed. Set the
instrument parameters for appropriate operation where necessary.
For details to set data, refer to sections 7 to 10.
Document all user changes to the operational configuration.
WARRANTY
• The warranty statement for this product can be found at the Teledyne Monitor Labs web site:
http://www.teledyne-ml.com/
• Customer shall notify TML of a defect within the warranty period and request a return authorization
number and designated TML repair facility. Customer shall return the defective part or parts to the
designated TML Customer Service Facility as set forth below, freight prepaid by the customer. TML
will prepay the return freight.
• TML will notify the customer of TML’s decision to repair or replace the defective part and the
expected shipment date.
• At the customer’s request, TML may elect to repair defective product(s) located in North America on
site, in which case travel expenses, travel time, and related expenses incurred by TML personnel
(excluding repair time) shall be paid by the customer.
Teledyne Monitor Labs Service Response Center 1-800-846-6062
www.teledyne-ml.com
35 Inverness Drive East, Englewood, Colorado 80112-5189 USA
Tel: [phone], Fax: [phone]