Installation manual

Publication 1394-IN002B-EN-P — February 2004

Installing Your 1394 SERCOS Interface System 1-19

5. Hang the AM50/75 axis module on the next mounting fastener.

6. Engage the alignment tab (refer to Figure 1.12).

Figure 1.12

Alignment Tab

If you are mounting a: Do this:

1394x-AM03, -AM04 or -

AM07; 1394C-AM50-IH,

or -AM75-IH axis module

1. Hang the axis module on the next

mounting fastener.

2. Go to main step 6.

1394x-AM50 or -AM75

axis module with the

heat sink through the

back of the enclosure

(refer to Figure 1.4)

1. Remove the paper backing from

the gasket that came with the

AM50/75 axis module.

2. Position the gasket so that the

sticky side faces the axis module

and the small hole side is on top.

3. Slide the gasket over the heat sink

and attach it to the back of the axis

module.

Figure 1.11

Gasket Position

4. Go to main step 5.

gasket

Engaged alignment tab