Instruction manual

11
© 2010 Directed Electronics. All rights reserved.
Press a fourth time within five seconds. The siren chirps four times
followed by a long chirp. Zones 2 and 4 are now bypassed.
Press a fifth time within five seconds. The siren chirps five times
followed by a long chirp. All input zones, except the ignition are now
bypassed.
Note: Multi-level security arming only applies to a single arming cycle.
Once the system is disarmed and then re-armed, all the zones will be
active again.
Arming while driving (security only)
Your security system can be armed while driving the vehicle.
Press
on the remote control for two seconds while the vehicle is
running. The siren/horn will sound once to indicate that the security
system is armed, and then once more to indicate that the ig ni tion is on.
The system will not respond to any input except the door triggers, and
the starter kill relay (if installed) will not be activated. Once you have
arrived at your des ti na tion, the system will disarm when the ignition is
turned off. The siren/horn will sound twice and the LED will then stop
flashing. The system can also be disarmed at any time by pressing
High security disarm (security only)
This security system offers High Security Disarm. High Security Disarm
is a feature that makes it possible to silence and reset the system while
it is triggering, without disarming the system.
If the system is triggered and the siren has been sounding for longer
than six seconds, pressing
on the remote silences the siren while
keeping the system in the armed state. The system does not disarm,
but resets. Pressing
again after silencing the system will disarm the
system.