Instruction Manual

Diamond PD Power Drive : Instruction Manual
Dominator Tempo & Syncro Instruction Manual ATS-3AM & ATS-2AM
15
© Copyright 2019
6.5 Safety Testing
Fig.6.5.2
2”x 4” board
6.5.1 Obstruction Detection Test
Check the Safety Beam photoelectric sensor is operating after the installation.
a. Place an obstruction (white vertical surface 6 in. high by 12 in. wide) in the
center of the opening, perpendicular to the plane of the door when in the
closed position as per Fig 6.5.1.
b. Press the CLOSE button
or the Premium Remote Control button to close
the door. The photoelectric sensor shall sense an obstruction as described
above. The door will not move more than an inch (2.54cm), and the opener
lights will flash.
6.5.2 Test the Close Cycle and Safety Reversal
a. Press the OPEN button or Premium Remote Control button to open the
door (If the door starts closing, press the Premium Remote Control button to
stop the door, then press Premium Remote Control button again to open).
b. Place an object approximately 1-
1
/
2
” to 1” (25mm) high (or a 2”x 4” board
laid flat, with 2” facing the door) on the floor directly under the door,
Fig 6.5.2.
c. Press the Premium Remote Control button to close door.
d. The door should strike the object and re-open wihthin 2 seconds.
e. Remove the timber.
6.5.3 Testing the Open Cycle
a. Press the CLOSE button or Premium Remote Control button to close
the door.
b. Press the Premium Remote Control button again to open the door.
c. When the door reaches approximately half way, firmly grab the door’s
bottom rail - the door should stop.
If the door does not reverse readily when closing, or stop when opening, put the
door into manual by pulling down on the manual release string to disengage the
motor and contact your dealer for support.
6.5.4 Test the Manual Door Operation
Periodically disengage the opener and manually operate the door. The door
must be smooth to operate by hand. The force required on the bottom rail
should not exceed 44lbs (20kg).
CAUTION: Take care when testing the safety
obstruction force. Excessive force may cause serious
personal injury and/or property damage can result
from failure to follow this warning.
ATTENTION: Testez la résistance aux obstacles avec
précaution. Une force excessive présente un risque
de blessure corporelle grave et/ou d’endommager le
matériel si vous ne respectez pas cet avertissement.
Fig.6.5.1
IMPORTANT WARNING! If the door is closing and is
unable to re-open when obstructed, discontinue use.
DO NOT use a door with faulty obstruction sensing. Repair
fault and re-test before using.
AVERTISSEMENT: Si la porte est en train de se refermer et
ne peut pas être rouverte, arrêtez de l’utiliser. N’utilisez pas
une porte dont les détecteurs d’obstacles sont défectueux.
Réparez-les et refaites un essai.