Instruction Manual

ManualsBrandsAutomatic Technology ManualsElectronicsDOMINATOR SYNCRO Overhead Garage Door Operator

Diamond PD Power Drive : Instruction Manual

Dominator Tempo & Syncro Instruction Manual ATS-3AM & ATS-2AM

D - Battery Functions

a. Holding the STOP button for 10secs when running from battery backup will shut the PCB down so as to reduce battery current consumption to a

minimum.

b. Holding the STOP button for 4secs when a battery is fitted and running from mains power will cause the controller to test the battery state to

determine if it is disconnected / open circuit, missing, faulty or ready.

Adjusting Safety Obstruction Force

The Safety Obstruction Force is calculated automatically during setup. Adjusting this is normally only necessitated by environmental conditions such as

windy or dusty areas, and areas with extreme temperature changes.

C - Adjusting Force Margins

Prior to limit set up, the opener can be set to J-Type Tilt Profile. This process allows the opener to pre-set to J-Type settings where the limit is not greater

than 1500mm. If J-Type is selected, the speed is customised and cannot be changed.

a. Press the MODE button repetitively until the GEAR

LED starts flashing.

b. Press and hold STOP / SET button for 2 seconds to check the door type, until the main courtesy light turns solid ON or OFF.

• Main courtesy light ON - Tilt type (J-Type only)

• Main courtesy light OFF - Sectional type

c. Press and hold STOP / SET for 6 seconds to change the door type, until the main courtesy light turns solid ON or OFF. If required, repeat step b to

check the door type selected.

d. Press MODE button to exit the door selection mode. Proceed to Section 6.4 to set the limits.

E - Setting up Tilt Door

To Increase / Decrease Force Pressure

a. Press the MODE button repetitively until the GEAR LED is flashing.

b. The LED will start flashing with one flash every second.

c. Press the STOP / STEP button and the MODE button LED and the TRANSMIT

LED will be lit and the GEAR LED will flash once every second.

d. By pressing the OPEN button

will increase the force pressure and CLOSE

button

will decrease the force - Main light will dim or brighten as the

pressure is decreased or increased.

e. Press STOP / SET button to save the new value. (Refer to

Appendix B for margin settings)

f. Test the force again as per Testing Close Cycle and Testing Open Cycle.