Instruction Manual

34
ATS-3AM & ATS-2AM Dominator Tempo & Syncro Instruction Manual
a. Switch power on and the BLUE LED on the CLOSE button will
start to flash to indicate that the opener is ready to set the Close travel
limit
b. Press the MODE button repetitively until the TRANSMIT
LED is lit.
c. Press and HOLD the CLOSE button
to set the Open / Stop /
Close function. The Main light will start to flash rapidly.
d. Press and hold button 1 on the Premium Remote Control, then release
remote control button.
e. Press and hold button 1 on the Premium Remote Control button again
until the main light stops flashing rapidly.
f. Release both buttons. The remote control button is now coded, press
to test and observe the speed of the door through a full cycle.
g. The drive speed is set to the fastest setting by default. This may not be
suitable for larger doors or for single piece doors:
G - Setting limits via Premium Remote Control
Button 1
(inch Open)
Button 2 (Set)
Button 4
(inch Close)
CLOSE limit:
(i) Using the programmed Premium Remote Control, press and hold the
button 4 to close. To inch the door, single presses of the button 4 will
move the door to desired limit.
(ii) While inching (to CLOSE) to set the close speed, press
and hold button 4 on the remote and by pressing the
SET button 2 the opener will cycle through all three speed modes as
shown in table.
(iii) Once at the desired speed, release the remote button 4.
(iv) Continue inching the door to the desired position. We recommend the
CLOSE limit position being the first point of contact of the rubber strip (
at the bottom of the door) with the ground.
(v) If the door overshoots, press the OPEN button 1 on the remote to move
the door in the OPEN direction.
(vi) When the door is at the desired CLOSE position, press the SET button 2,
the GREEN LED on the OPEN button
will now flash.
OPEN limit:
(i) Using the programmed Premium Remote Control, press and hold
the button 1 to open. To inch the door, single presses of the button
1 will move the door to desired limit.
(ii) While inching (to OPEN) to set the open speed, press
and hold button 1 on the remote and by pressing the
SET button 2 the opener will cycle through all three speed modes
as shown in table.
(iii) Once at the desired speed, release the remote button 1.
(iv) Continue inching the door to the desired position. We recommend
the OPEN limit position being the height of the garage opening
(v) If the door overshoots, press the CLOSE button 4 on the remote to
move the door in the CLOSE direction.
(vi) When the door is at the desired OPEN position, press the SET
button 2. The door will now automatically close and open to
calculate the safety obstruction settings.
WARNING! The door will automatically close, open and
close again after the next step. Ensure that nothing is
in the door’s path.
AVERTISSEMENT: La porte va se fermer puis s’ouvrir
automatiquement, avant de se fermer. S’assurer que
rien ne bloque l’ouverture ou la fermeture de la porte.
When activated, PET mode drives the door to a preset position from the close position,
therefore allowing a pet or parcel to go under the door.
a. Drive and stop the door at the desired PET mode open position by pressing the
transmitter button coded for Open/Stop/Close operation.
b. Press the MODE button repetitively until the GEAR
LED is lit.
c. Press OPEN button
to save PET position - Main light will flash and both OPEN and
CLOSE LED will light up.
F - Setting the PET Mode position