Installation manual

Owner Installation Instructions GDO-8V2 EasyRoller® II 13

Setting limits

5. Fixing of door curtain to drumwheel

The door curtain has to be secured to the drum wheel

with suitable fasteners. This prevents unauthorised

access through the door by pushing the curtain up and

off the drum.

1. With the door in the fully closed position, mark the

curtain (Fig. 07) on both ends of the door.

2. Open door slightly to have access to the marked

positions. Secure the curtain to drum wheel using

self drilling screws (two on each end). The screws

should be at least 90 degrees apart.

6. Setting door travel limits

IMPORTANT NOTE: The OPERATE button will

not function until the open and close limits

positions are set.

6.1 Coding transmitter for setting limits

1. Press and hold the Door Code button (Fig. 09).

2. Press button 1 (Fig. 11) on the transmitter for

two seconds.

3. Release and pause for two seconds.

4. Press the same button transmitter again for

two seconds.

5. Release the Door Code button.

6.2 Setting datum position

1. Switch the opener into manual mode (Fig. 08).

2. Move the door by hand to an approximately mid

open position.

3. Re-engage the opener.

4. Using a small blade screw driver turn the datum

adjust screw slowly until the yellow status LED just

illuminates.

NOTE: If the status LED is already illuminated when

power is connected then turn the datum adjust screw

until the LED goes off then turn back one notch to

illuminate again.

ﬁ g

Drum wheel

90°

Pull handle down to

disengage or re-engage