Installation manual

GDO-8V2 EasyRoller® II Owner Installation Instructions

Parameters

Door Status Indicators

Door Opener State Open LED

Green

Close LED

Red

Door Status

LED yellow

Beeper

Open On

Close On

Opening Flashing

Closing Flashing

Door travel stopped Flashing

Door obstructed when

opening

Flashing

Door obstructed when closed Flashing Beeps

while door

is moving

Opener overloaded Alternating ﬂ ashes Alternating ﬂ ashes

Mains power interupted Rapid ﬂ ashes

Buttons Function

Operate Opens/Stops/Closes the door

Door code Codes a transmitter button for OPERATE function

Force Margin Set + plus (+) Increases the obstruction force margin setting

Force Margin Set + Minus (-) Decreases the obstruction force margin setting

Force Margin Set (then) Set Reloads the factory set default obstruction force

margin setting

Close for 6 seconds Clears the door limits set positions. Limits then need

to be reset

Set (then power on) & hold until all LEDs are off Deletes control parameters excluding transmitter

storage memory

Door Code (then power on) & hold until all LEDs

are off

Deletes all transmitter stored in memory.

Set for 2 seconds Re-initialises the Opener to re-calculate force margins

Purchased from: Phone:

Installed by: Date:

Serial No: