Installation manual

Owner Installation Instructions GDO-8V2 EasyRoller® II 5
The EasyRoller® II is not intended for use by young children or infi rm persons without adequate supervision.
Children should be supervised to ensure they do not play with the remote transmitters or the EasyRoller® II.
Keep hands and loose clothing clear of the door and EasyRoller® II at all times.
The unit is rated to IP24, however, it should be installed so that it is protected from the elements. Where
possible it should not be exposed to water or rain. It is not to be immersed in water or sprayed directly
by a hose or other water carrying device.
The garage door must be well balanced. Sticking or binding doors must be repaired by a qualifi ed
garage door installer prior to installation of the EasyRoller® II.
Frequently examine the installation, in particular cables, springs and mountings for signs of
wear, damage or imbalance. DO NOT use if repair or adjustment is needed since a fault in
the installation or an incorrectly balanced door may cause injury. DO NOT attempt to repair
the door yourself as hardware is under extreme tension.
Remove or disengage all garage door locks and mechanisms prior to installation of
the EasyRoller® II.
Connect the EasyRoller® II to a properly earthed general purpose 240V mains
power outlet installed by a qualifi ed electrical contractor. The outlet (and
EasyRoller® II) must be positioned so that it is easily accessible.
Disconnect the power cord from mains power before making any repairs
or removing covers. Only experienced service personnel should remove
covers from the EasyRoller® II.
In order for the EasyRoller® II to sense an object obstructing the
door way, some force must be exerted on the object. As a result
the object, door and/or person may suffer damage or injury.
If the power supply cord is damaged, it must be replaced by
an Automatic Technology service agent or suitably qualifi ed
person.
Make sure that the door is fully open before
driving in or out of the garage and fully closed
before leaving the driveway.
Make sure that remote controls are
kept out of reach of children.
Important safety instructions