Installation manual

CODING TRANSMITTERS
- 18 -
©Copyright 2006 Automatic Technology
STEP 19
STORING TRANSMITTER(S) FROM A REMOTE
LOCATION
Using this method you don’t need to have access to the
control panel on the Door Opener. However, you do
need a transmitter that is pre coded to the controller’s
receiver.
IMPORTANT NOTE: The Door or Courtesy Light must
be activated when the step below is performed. The
moving Door or Light switching on is to confirm from a
remote location that, the correct button was pressed,
and the transmitter is in range of the Opener.
1. Take any pre-coded transmitter. Press the button for
the function you require until the door is activated
and release.
2. Then using a small needle press and hold firmly for
two seconds through the Coding Hole (Fig. 27)
3. Within 10 seconds take the additional transmitter you
wish to code.
4. Press the button (one of four) on that transmitter you
would like to use to control the door for two seconds,
pause for two seconds. Press the same button again
on the transmitter for two seconds, the button should
now be recorded.
5. Wait for 10 seconds and then press the recorded
transmitter button to see if it operates the door.
20. DELETING PROGRAMMED CODES
20.1 DELETING A STORED TRANSMITTER CODE
1. Select the transmitter you want to delete.
2. Press and hold the Door Code button (Fig. 28).
3. Press the transmitter button you would like to delete
for two seconds. Pause for two seconds. Press the
transmitter button again for two seconds.
4. Release the Door Code button. The code should now
be deleted. Confirm this by pressing the transmitter
button, the door should not respond.
20.2 DELETING ALL STORED TRANSMITTER
CODES
1. Turn the Power Off to the Opener.
2. Press and hold the Door Code button (Fig. 28).
3. Turn the Power On again, while holding the Door
Code button. The Open Limit, Close Limit and Door
Status LED’s will illuminate for about five seconds.
These LED’s will turn Off and the Coding LED will
illuminate. Release the Door Code button. All the
stored codes including the Courtesy Light codes
should now be deleted. Confirm this by trying to
operate the door by pressing the transmitters
previously used to control the door, the door should
not respond.
Fig. 28
Fig. 27