Installation manual

ManualsBrandsAutomatic ManualsGarage Door OpenerGDO-11v1 Ero

Owner Installation Instructions GDO-11v1 Ero

Mounting Door Bracket & Arms

ﬁ g

Step 12 - Mounting Door Bracket

The door bracket comes in two parts. The bottom plate

with two mounting holes is used on its own for one piece

doors. For sectional doors, the top plate is placed over

the bottom plate and is ﬁ xed with four (4) screws (Fig.

24).

Mount the door bracket, or bracket assembly,

on the door’s centre line one-third down the top

panel (Fig. 24) using M6 or equivalent screws (not

supplied),

STEEL DOORS ONLY: Bracket can be welded in

place.

NOTE: If in doubt about the door’s strength,

reinforcement may be added to the door’s frame

where necessary. Door damage may occur if the

bracket is installed on a panel with insufﬁ cient

strength. The opener’s warranty does not cover

damage caused to the door and/or door panels.

Step 13 - Attaching the Arms

For Sectional And One Piece Doors With

Track:

Assemble the bent arm (connecting to the door)

to the right side of the straight arm (connecting

to the shuttle) with bolts and nuts supplied in the

accessory pack (Fig. 25). Always use both bent and

straight arms.

Connect the assembled arm to the bracket and the

disengaged trolley with clevis and snap pins. The

angle “A” must be more than 10° (Fig. 26).

WARNING: Connecting the bent arm the other

way around may damage the door. The straight

arm should not protrude beyond the heel of the

bent arm.

For One Piece Doors Without Track

Assemble the bent and straight arms as shown in

Fig. 27 with bolts and nuts supplied in the accessory

pack. Always use both the bent and straight arms.

Connect the assembled arm to the bracket and the

disengaged trolley with clevis and snap pins.

If installing on a door with a bad wave action,

lengthening the arm will assist in reducing this

effect.

IMPORTANT NOTE: Adjust the length of the

cord so that its toggle is no more than 1.8m from

the ground.

ﬁ g

Bent arm connected

to the door

Straight arm

connected to the

shuttle

Centre of the door