Installation manual

ManualsBrandsAutomatic ManualsGarage Door OpenerGDO-9v2 SecuraLift

GDO-9

Owner Installation Instructions

Programming The Opener

ﬁ g

Setting Travel Limits : Via Control Panel

Step 13.1 - Setting Travel Limits

NOTE: If PE Beams are to be used they must be installed

before setting the travel limits.

WARNING! Use caution when operating the manual

release with the door open since it may fall rapidly

due to weak or broken springs, or an improperly

balanced door.

CAUTION! Do not disengage the opener to manual

operation with children, persons or any objects

including motor vehicles within the doorway.

Engage the C-Rail’s trolley (attached to the door via

the arms) with the chain index by moving the door.

If the trolley does not “click” ﬁ rmly onto the chain

index, ensure that the manual release cord is not in

the disengaged position by pulling it backwards.

Turn on the power to the opener. The CLOSE LIMIT

LED will be ﬂ ashing.

Remove the button cover with a blade screwdriver

(Fig. 22).

Press and hold the MINUS (-) button - the door will

start closing (Fig. 23).

Release the MINUS (-) button when the door is near

the desired closed position. Single presses of the

MINUS (-) button will “inch” the door closed.

If the door overshoots press the PLUS (+) button to

move the door in the open direction.

When the door is at the desired close position, press

the SET button to record the close limit position. The

OPEN LIMIT LED will now ﬂ ash.

Press and hold the PLUS (+) button to open the door

(Fig. 24).

Release the PLUS (+) button when the door is near the

desired open position. Single presses of the PLUS (+)

button will “inch” the door open.

If the door overshoots press the MINUS (-) button to

move the door in the open direction.

WARNING! Once the next step is performed, the

door will automatically close and open to calculate

force settings. Keep persons and objects clear of the

door until it stops and the opener sounds a beep.

Press the SET button to store the open limit. Please

read the above warning.

Step 13.2 - Resetting Travel Limits

To reset the limits, press and hold the MINUS (-) button for

6 seconds until the CLOSE LIMIT LED ﬂ ashes quickly. If no

action is taken within 30 seconds, the opener will return to

normal operating mode and restore the original settings.