Instruction manual

6
• Onlyuseaccessorybitsingoodcondition.
• Beforedrilling,checkthatthereissufficientclearancefor
the drill bit under the workpiece.
• Donottouchthebitafteroperation.Itwillbeveryhot.
• Keepyourhandsawayfromundertheworkpiece.
• Neveruseyourhandstoremovesawdust,chipsorwaste
close by the bit.
• Rags,cloths,cord,stringandthelikeshouldneverbeleft
around the work area.
• Supporttheworkproperly.
• Ifyouareinterruptedwhenoperatingthedrill,complete
the process and switch off before looking up.
• Periodicallycheckthatallnuts,boltsandotherfixingsare
properly tightened.
• Whenusingthedrill,usesafetyequipmentincluding
safety glasses or shield, ear defenders, and protective
clothing including safety gloves. Wear a dust mask if the
drilling operation creates dust.
If in doubt, do not plug in the tool. Using a power source with a
voltage less than the nameplate rating is harmful to the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to
eliminate all residual risk factors. The following hazards may
arise in connection with the tool’s construction and design:
• Damagetothelungsifaneffectivedustmaskisnotworn.
• Damagetohearingifeffectiveeardefendersarenotworn.
Additional safety instructions for the charger
• YourAUTOMATICtoolwithLithiumIonbatteriesmay
only be charged with the specific designed AUTOMATIC
Lithium Ion battery charger purchased with the tool.
ITISDANGEROUSTOUSEANYOTHERBATTERY
CHARGER TO CHARGE YOUR TOOL. Do not attempt
to charge the battery pack with any other charger than
the one supplied.
• Ifthereisaproblemwiththebatteryorthetool,takeit
to your nearest Authorised Service centre or phone and
speak with an experienced AUTOMATIC Customer Service
Representative for assistance in rectifying your problem.
• Beforeusingthecharger,readalltheinstructions,labels
and cautionary markings on the charger and battery pack
as well as the instructions on using the battery pack.
• Donotusethechargerifithasbeensubjectedtoa
heavy knock, dropped or otherwise damaged in anyway.
Take the charger to an authorised service centre for a
check or repair.
• Donotdisassemblethecharger.Openingorremoving
covers may expose you to dangerous voltages or other
risks. Incorrect reassembly can cause electric shock
when you use the tool or charger again. Take the charger
to an authorised service centre when service or repair
is required. Incorrect re-assembly may result in the risk
of fire, electric shock or electrocution. To reduce the risk
of electric shock, do not disassemble any part of the
product.
• DANGER. If the battery pack is cracked or damaged in
any other way, do not insert it in the charger
• DonotpluganythingotherthanyourAUTOMATICtool