Instruction manual

Coal-trol Digital™ - Model TS2 V3
Automation Correct LLC
5/2010 R0
www.automationcorrect.com
Page 2
Instruction Manual
Coal-trol Digital Feature Overview
The Coal-trol Digital is a complete control system designed for
automatically fed stoker stoves and furnaces utilizing anthracite fuel. The
stove-mounted Control Module and the wall-mounted Coal-trol Thermostat
work together to supervise all stove operations and typically maintain room
temperature to within ±1°F of the desired setting.
The Control Module controls the coal feed rate, combustion blower fan,
convection blower fan, and fire igniter accessory, when installed.
All connections to stove blowers, motors, and safety interlocks are done
through standard 120VAC cord receptacles or plug connectors on some
configurations.
The Coal-trol Thermostat may be located up to 100 ft. from the Control
Module. Proper temperature control only requires that the heat generated
by the stove be readily communicated to the thermostat.
Fuel feed is continuously adjusted to maintain room temperature as set on
the Coal-trol thermostat. The convection blower is automatically started and
speed adjusted according to amount of fuel fed into the stove.
Two temperature setbacks automatically change the temperature at
prescribed times set by the user on a 24 hour time cycle.
A room high temperature limit shuts off the stove if feeder failure occurs.
Manual speed setting of the convection blower is provided for occasions
when reduced fan noise is desired.
A fuel feed mode assists in starting a fire by feeding fuel for 10 minutes at a
100% rate.
All settings, except for time of day clock, are maintained during power loss
without batteries.
Power loss ride-through allows the thermostat to continue stove operation if
power is restored within 2 hours.
Test Mode sequences all motors and blowers to assist in installation and
troubleshooting.
The Coal-trol Digital TS2 Thermostat features an LCD display, one LED
indicator, and 3 pushbuttons for indication and control of all settings.
User initiated fire start and fire stop controlled from the Thermostat.
(Additional hardware required).