Instruction manual

T4x-SERIES QUICKSTART GUIDE
16
Note: The strobe signal connection is shared with Output 3. If a non-zero value is defined for the Strobe Pulse Length
value (in VPM – Impact – General), the strobe is active. If the value is zero, Output 3 is active.
CAUTION
Power is available directly to the Output Device, independently from the
Power Supply Switch inside the CBX.
Figure 14 - Open Emitter Output Using CBX Power Figure 15 - Open Collector Output Using CBX Power
OUTPUT CONNECTIONS USING EXTERNAL POWER
Figure 16 - Output Open Emitter Using External Power
Figure 17 - Output Open Collector Using External Power
EXTERNAL ILLUMINATORS
If an External Illuminator (strobe light) is used, it can be powered from the CBX connection box.
It must be connected to the Vdc and GND terminal clamps. The strobe signal connection is
shared with Output 3. If a non-zero value is defined for the Strobe Pulse Length value (in VPM –
Impact – General), the strobe is active. If the value is zero, Output 3 is active.