Instruction manual

T4x-SERIES QUICKSTART GUIDE
6
2. Remove the sensor protection label (dust cap) by pulling it off of the base.
3. Mount a lens by slowly screwing it onto the base until it arrives at the mechanical stop.
Figure 1 – Assembling the Camera and Lens
4. To keep dust and dirt off of the lens during mounting, temporarily replace the lens cover.
Connect the System
In the typical standalone layout shown in the figure below, an EtherNet host is connected to the
camera. The camera can use an external trigger to signal image acquisition.
The CBX is used to facilitate the connection between the camera and the host interface, external
trigger, and optional input and output devices.
T4x-Series™ Standalone Layout to Ethernet Host
CAB-GE0x
CAB-PG-0002
+ BA400
CAB-SCSxx
PG-120
Ext. Trigger
CBX500
I/O
Ethernet Host
(Data collection + T4x-
Series configuration)
Camera
Lens
Lens Cover
Protective Film on front of cover
(remove before calibration)
Camera
Anti-vibration components
(optional)