Specifications

C4-1280-GigE Camera Hardware Reference Manual Rev. 1.8 • 13
Name Rev. Interface Access Description
ReverseY 1.0 IBoolean R/W When set to true, this parameter flips the image
vertically.
OffsetX 1.0 IInteger R/W X Offset of AOI
TestImageSelector 1.0 IEnumeration R/W Selection of the test image to be used.
- Off
- GreySensorColumnPattern
LinePitch 1.0 IInteger R Distance between consecutive lines in bytes.
PixelDynamicRangeMin 1.0 IInteger R Minimum pixel value sent by the camera.
PixelDynamicRangeMax 1.0 IInteger R Maximum pixel value sent by the camera.
AcquisitionControl
Name Rev. Interface Access Description
AcquisitionStart 1.0 ICommand W Issues the START command. This starts the
acquisition.
AcquisitionStop 1.0 ICommand W Issues the STOP command. This stops the
acquisition.
AcquisitionMode 1.0 IEnumeration R/W Defines the type of acquisition:
- SingleFrame
- MultiFrame
- Continuous
AcquisitionAbort 1.0 ICommand W Issues the ABORT command. This immediately
aborts the acquisition without completing the current
frame.
AcquisitionFrameCount 1.0 IInteger R/W Number of frames to be acquired in MultiFrame
acquisition mode. The minimum allowable value is 1.
AcquisitionFrameRateAbs 1.2 IFloat R The frame rate of the imager. Absolute units are in
Hz.
AcquisitionStatusSelector 1.2 IEnumeration R/W Selector for AcquisitionStatus to read:
- AcquisitionTriggerWait
- AcquisitionActive
- AcquisitionTransfer
- FrameTriggerWait
AcquisitionStatus[AcquisitionStat
usSelector]
1.2 IBoolean R Status of the selected acquisition flag
CameraControls – AOIs (Areas Of Interest)
Name Rev. Interface Access Description
MaxNumAOIs AT IInteger R Maximum number of AOIs.
NumAOIs AT IInteger R/W Number of used AOIs.
ImageModeAoiSelector AT IInteger R/W Selects the AOI to show in image mode
AoiSelector AT IInteger R/W Selects which AOI to control
AoiHeight AT IInteger R/W Number of sensor rows in AOI
AoiOffsetY AT IInteger R/W Offset distance in rows between the first row of AOI
and the first row of sensor chip
AoiThreshold AT IInteger R/W Intensity threshold value for selected AOI.
CameraControls – ModeAndAlgorithmControls
Name Rev. Interface Access Description
CameraMode AT IEnumeration R/W Selects the camera mode or algorithm:
- Image
- CenterOfGravity
- Threshold
- MaximumIntensity
ProfilesPerFrame AT IInteger R/W This feature represents the number of Profiles per
Frame in 3D-Mode expelled by the camera.
AbsOffsetPos AT IBoolean R/W True: Position values are referenced to the first row
of sensor chip (absolute position).
False: Position values are referenced to the first row
of AOI.
TrshFirstFalling AT IBoolean R/W Stops the position calculation along an AOI column,
as soon as the falling edge of a Gauss curve is
detected.
NumCOGSP AT IInteger R/W Number of subpixel bits of COG output (0-6).
PosValidationEn AT IBoolean R/W Enable validation of position value of a Gauss curve
using tolerances for width and sum of intensity.
Perform validation during scan of image column and