Specifications

C4-1280-GigE Camera Hardware Reference Manual Rev. 1.8 • 15
NDRMode AT IEnumeration R/W Non Destructive Readout (NDR) Mode:
- Off
- On
- SingleFrameMode.
NDRSingleFrameNumber AT IInteger R/W NDR single frame number.
NDRExposureTimeAbs_1 AT IInteger R/W NDR exposure time 1.
NDRExposureTimeAbs_2 AT IInteger R/W NDR exposure time 2.
NDRExposureTimeAbs_3 AT IInteger R/W NDR exposure time 3.
NDRExposureTimeAbs_4 AT IInteger R/W NDR exposure time 4.
CameraControls – SensorControls – AdvancedSensorsettings
Name Rev. Interface Access Description
FPNCorrection AT IEnumeration R/W FPN Correction:
- Enable
- Disable
GainAbs 1.2 IEnumeration R/W Gain value:
- 1
- 1.5
- 2
- 2.25
- 3
- 4
AntiBlooming AT IFloat R/W Antiblooming Voltage (DAC 1)
ResetTS AT IFloat R/W Reset Voltage Triple Slope (DAC 2)
Reset AT IFloat R/W Reset Voltage (DAC 3)
ResetDS AT IFloat R/W Reset Dual Slope (DAC 4)
Precharge AT IFloat R/W Precharge Voltage (DAC5)
MemH AT IFloat R/W Pixels memory element high level (DAC6)
MemL AT IFloat R/W Pixels memory element low level (DAC7)
BlackLevelAdjust AT IInteger R/W Adjustment of black level.
Enable automatic SERDES
recalibration
AT IBoolean R/W Enable automatic SERDES recalibration on data
channel error.
CameraControls – DataOutput
Name Rev. Interface Access Description
EnableDC0 AT IBoolean R/W Activates the output data channel DC0.
EnableDC1 AT IBoolean R/W Activates the output data channel DC1.
EnableDC2 AT IBoolean R/W Activates the output data channel DC2.
EnableDC0Shift AT IBoolean R/W Right shift twice the intensity value in DC0, when
PixelFormat is Mono8.
EnableDC2TrshSP AT IBoolean R/W Controls the output in channel DC2, when TRSH
algorithm is selected:
True: DC2 outputs the position value with 1
subpixel.
False: DC2 outputs the right edge position.
EnableDC1TrshWidth AT IBoolean R/W Controls the output in channel DC1, when TRSH
algorithm is selected:
True: DC1 outputs the laser line width.
False: DC1 outputs the left edge position.
EnableDC1Width AT IBoolean R/W Controls the output in channel DC1, when COG
algorithm is selected:
True: DC1 outputs the laser line width.
False: DC1 outputs the left edge position.
EnableDC1Flags AT IBoolean R/W When in 16 bit mode, the bits 12-15 of output
channel DC1 contain additional algorithm flags
CameraControls – Commands
Name Rev. Interface Access Description
StartPulse AT ICommand W Send Start pulse.
StopPulse AT ICommand W Send Stop pulse.
TriggerPulse AT ICommand W Send Trigger pulse.
CalibSensor AT ICommand W Start internal sensor FPN calibration.
RstFrameCnt AT ICommand W Reset frame counter to zero.
SearchAoi AT ICommand W Fit AOI to laser line position. Supports only one
AOI