User guide

Touch Screen Driver Installation for Windows 2000
Required items to know or have to install the Touch Driver.
 What Operating System you are using. Windows 2000
 What Serial Port you are connected to. Usually COM 1 or COM 2
 The type of touch screen. Smartset
 The CD-ROM or Floppy disk included with the system.
Touch Screen Driver Installation for Windows 2000
 Insert the provided CD
 Select Link to Windows 2000 driver
 Select Open from the Windows dialog box.
 Select Next
 Select Yes - To the license agreement
 Select the Com Port to which the touch interface is connected and Next
 Select Next, the driver will now start to install.
 Select YES - To continue
 Select Finish
 Remove the CD.
 Select YES to Restart.
 When the system restarts touch each of the 3 targets as directed.
 If the unit does not respond to your calibration touches then you have
probably selected the wrong COM port. If so, press the Esc key to exit.
 Go to the ELO icon under Windows Control Panel.
 Select the correct Com port, and restart the computer.
 Once restarted, select the ELO icon under Windows Control Panel
 Select Align and Calibrate; then touch each of the 3 targets as directed.
 You are now ready to use your touch screen.
Note 1: The touch screen calibration information is maintained in the computer. If you
change computers, you will need to reinstall the touch screen driver software and
recalibrate.
Note 2: If for any reason the touch screen performance is unsatisfactory, you can
recalibrate at any time. This is done from the ELO icon under the Windows control panel