Operating instructions

3
Copyright © 2013 Autonomic Controls, Inc. All Rights Reserved
1. AC Fuse
The AC fuse inside the device is not user-serviceable. If you
cannot turn on the device, contact the dealer from whom you
purchased this device.
2. Care
Occasionally you should dust the device all over with a soft
cloth. For stubborn stains, use a soft cloth dampened with
a weak solution of mild detergent and water. Dry the device
immediately afterwards with a clean cloth. Don’t use abrasive
cloths, thinners, alcohol, or other chemical solvents, because
they may damage the finish or remove the panel lettering.
3. Power
WARNING
BEFORE PLUGGING IN THE DEVICE FOR THE FIRST TIME, READ
THE FOLLOWING SECTION CAREFULLY.
AC outlet voltages vary from country to country. Make sure
that the voltage in your area meets the voltage requirements
printed on the device’s rear panel. (e.g. AC 90V – 240V
50/60HZ) The power cord is used to disconnect this device
from the AC power source. Make sure that the plug is readily
operable (easily accessible) at all times. If you do not intend to
use the device for an extended period, remove the power cord
from the AC outlet.
4. Ground
The device is defined as Class1 in EN60065 (low voltage
directive) and MUST BE GROUNDED. Connect only to an outlet
with protective ground, and only use the powercord supplied.
Finland:“Laite on Liitettävä suojamaadoituskoskettimilly
varustettun pistorasiaan”
Norway: “Apparatet må tilkoples jordet stikkontakt”
Sweden: “Apparaten skall anslutas till jordat uttag”
PRECAUTIONS
5. Never Touch This Device With Wet Hands
Never handle this device or its power cord while your hands
are wet or damp. If water or any other liquid gets inside this
device, have it checked by your Autonomic dealer.
6. Handling Notes
a. If you need to transport this device, use the original
packaging to pack it how it was when you bought it.
b. Do not leave rubber or plastic items on this device for a
long time as they may leave marks on the case.
c. This device’s top and rear panels may get warm after
prolonged use. This is normal.
d. If you do not use this device for a long time, it may not
work properly the next time you turn it on, so be sure to
use it occasionally.
7. Speaker Shorts
Under no circumstances should the speaker output terminals of
the device be short circuited, grounded or connected to
another output.
8. Direct Sun light
Avoid installing the device in positions where the front panel is
exposed to direct sunlight – may cause control to
become sluggish.
9. Controller Connection
Never connect more than eight keypads. The supply is internally
fused (self resetting) and may open circuit. Never connect the
device’s 12VDC terminal (“Bus Run” port) to an external
power supply.