Copyright Information All rights reserved by AU TOOL TECH. CO., LTD. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of AU TOOL. The information contained herein is designed only for the use of this unit. AU TOOL is not responsible for any use of this information as applied to other units.
Safety Precautions ® Catheterizes suitable for both 12V-and 24V vehicle batteries. @ Catheterizes suitable for operation at voltages ranging from 9v to 35v direct current(DC). ® If the battery's just fully charged,the voltage will be slightly higher than normal. Therefore, please turn on the headlights for 2-3 minutes and wait until the voltage drops back to normal. Then turn off the vehicle appliances and proceed the test.
Introduction This is an automotive battery tester with real time temperature monitoring, which is able to determine the exact degree of influence of temperature on the battery performance. The instrument adopts advanced conductivity testing technology, which can easily, quickly and accurately test the battery performance of cranking ability, cranking load, maximum load and charging system of the car battery. Iris convenient for the maintenance personnel to quickly repair the car.
Function instructions The tester is powered only by the vehicle battery. Clamp the red and black clips of the tester to the positive(+) and negative terminals of the battery safely and securely respectively. It is recommended to clip the red clamp first, then the black clamp, until the screen shows the following picture, the tester is in operation. ANE EBA uv If the tester indicates poor connection, recheck that if the clamp connection is completely secure.
@ According to your actual battery type, press the key to select the right "Battery Type", and press the key to proceed to the next step. BATTERY TYPE 1. Regular Flooded breastplate 3.AQN Spiral 4.GEL REFRESH @ According to the standard type of cranking current marked on the battery body, press the key to "Select Input” the right rated starting type, and press the key to proceed to the next step.
Life span | Test result Note >80% Good Battery's in good condition. > 60% Average Battery's condition is acceptable. >45% Alert Battery life is approaching and be careful. <45% Replace The battery life has expired, please replace. Cranking Test The tester will measure the voltage and discharge speed during the cranking process to determine the starting condition of the car. ® Make sure that the engine and all electrical appliances on the vehicle are turned off before testing.
Charge System The tester will test the charging system under load as well as empty load to determine how well the car's charging system is. ® Make sure that the engine and all electrical appliances on the vehicle are turned off before testing. ® Select "Main Menu", press the keys to select the "CHARGING SYSTEM" item and press the key to enter. ® Follow the steps on the tester screen, along with the actual operation of the MAIN MENU 1. BATTERY CAPACITY 2, CRANKING TEST ENT 63 03 4.DATAREVIEW 5.
Print report The vehicle to which the report belongs needs to be set according to the Vehicle Identification Number (VIN) before the report can be printed. @® Press the key to enter the code, then press the to enter the next value until the last value is finished. Press the key and the tester will print the result. VIN SETTING Data Review The tester automatically saves the last test record in each test item for later review.
Warranty There are 3 years warranty of the main unit from the date of the customer received the AU TOOL product and 1 year warranty for accessories.
