C3-RS-625 PROFESSIONAL 2-WAY AM/AM REMOTE CAR STARTER & KEYLESS ENTRY SYSTEM With Two-way Serial Port Data Link Compatible Please see page 15 of this manual for more details OPERATION MANUAL Please register your product at: www.autopageusa.
SYSTEM OPERATIONS: WARNINGS: As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while the vehicle is running on remote control. 3. Alert servicing personnel that the vehicle can be started automatically. 4. Do not start the vehicle by remote while it’s in an enclosed area or garage. 5.
CHANGING THE BATTERY IN YOUR TRANSMITTERS XT-33: This transmitter uses two (2) 3-volt lithium ion batteries (#CR2016) that are sandwiched together with the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top case from the bottom case. It should snap apart after breaking the seal.
SILENT LOCKING / UNLOCKING: Pressing the + buttons together on the transmitter will lock or unlock your system, No chirp sound will be heard. Lock / unlock confirmation will be seen through the vehicle’s parking lights only. ACTIVE UNLOCK: 1. Press button on the transmitter. 2. The horn will chirp twice and parking light will flash twice to indicating that the keyless system is now unlocked. The vehicle doors will unlock and dome lights will turn on for 30 seconds.
You can now start and operate the vehicle normally. VALET MODE: The valet switch allows you to temporarily bypass all system function, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, and remote start functions are bypassed, however, the remote panic feature and remote door locks will remain operational.
turned “OFF”. TRUNK RELEASE (Additional Installation Required) Press and hold the button on transmitter for two seconds to remote control the trunk release or other electric devices. CAR LOCATOR (ONLY IF SIREN or HORN IS INSTALLED) Press the button twice when the system is armed to active car locator function. The horn will chirp 6 times. The parking light will flash 12 times, for you to easily locate your car.
vehicle will remote start or remote shut down. (Programming Required) NOTE: The Remote Start Unit will not start the vehicle if any one of the following conditions exists: 1. The hood is opened. 2. The brake pedal is pressed. 3. The optional remote start enable toggle switch is in the OFF position. 4. The gear selector is in any gear other then “PARK” or “NEUTRAL” TO TURN OFF THE REMOTE START: When the engine is running (by remote start), if you want to stop it, 1. Press button once on the transmitter. 2.
A maximum of six cycles can occur. ENTER: 1. Press the button once to remote start the vehicle. As soon as the vehicle is running the parking lights will turn ‘ON’. 2. Immediately press the button then press button. The parking light will flash (3) times. The siren chirps (3) times. The vehicle is now programmed to start every (3) hours. 3. Press the brake pedal to stop the vehicle running. Exit the timer start: Timer start can be exited manually as follows: 1. Repeat the Enter Steps from above. Or 1.
Note: If the system is interfered by stronger radio frequency around, sources of high voltage electric power or such obstacles like tall buildings and so on, the transmission range may get shorter as the system uses low output powered frequency. BATTERY REPLACEMENT: A 1.5V type AAA Alkaline battery powers the Remote Transmitter. When the power of the battery weakens a icon shall be displayed on the LCD screen.
Start Mode Your vehicle is running Valet Mode Remote Transmission You are transmitting the signal to control unit In – Range Indicator You are within the remote control range. Low Battery All the function shall be temporarily on hold. Trunk Release Trunk open. Trunk symbol only. You have to replace the battery of remote control. Vibration Mode Remote Control vibrates when the system is triggered Power Save Mode Ignition On Driver paging Someone is paging you in front of your vehicle.
program the remote control transmitter to a second vehicle, follow the instructions for Transmitter programming. All programming parameters are the same except for the following: For Regular Remote Control Transmitter: 1. Prior to pushing any button on the transmitter. Press the Select II button first on the standard transmitter. 2. Once II button is pressed the LED on the transmitter will illuminate for 3.5 seconds.
Vibration / Melody Mode: Vibration mode is useful when you are in a noisy place and it is difficult to hear the beep sound from the remote control. In this mode the unit will vibrate if your security system is triggered. 1. Press and hold all four remote control buttons simultaneously until one long beep is heard. Programming has now been entered. 2.
and buttons at the same time. It will clear the flash icon and melody sound on the LCD screen transceiver. Stop The Trigger Melody Sound: While triggering the alarm the LCD screen will alert the user through melody sound and flashing trigger icon. Press any button on the LCD remote transmitter to stop the melody sound. LIMITED LIFETIME WARRANTY PROVISIONS ( U.S. ,Continental U.S. and Canada Only) 1. Auto Page, Inc.
occurring during the WARRANTY period. 4. Any equipment or parts which are claimed to be defective under this WARRANTY must be sent to the Auto Page Service center with “proof of purchase” at the purchaser’s expense prior to such return, a Return Authorization Number should be obtained. Auto Page will return the equipment, charges prepaid. Warranty Service can be provided through the dealer where the equipment is originally purchased. 5.
Warning: Some batteries may contain Perchlorate What is Perchlorate? Perchlorate is both a naturally occurring and manmade contaminant increasingly found in groundwater, surface water and soil. Most perchlorate manufactured in the U.S. is used as an ingredient in solid fuel for rockets and missiles. In addition, perchlorate-based chemicals are also used in the construction of highway safety flares, fireworks, pyrotechnics, explosives, common batteries, and automobile restraint systems.
It is recommended to have a minimal digital service plan on your cell phone Your RS-625 is CI3 compatible and will open your world to the true power of two way communication. Complete tracking and full cell phone functionality can be added to your system. For more information please visit your local authorized Autopage dealer or go to www.autopageusa.com .
Compatible 2-Way Communication to the Power of 3 960 Knox Street Unit B, Torrance, CA 90502 Tel: (310) 323-1800 or (800) 262-2527 www.autopageusa.
