RF-420LCD PROFESSIONAL VEHICLE SECURITY SYSTEM OPERATION MANUAL THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY
TRANSMITTER OPERATION: Transmitter Button System Function Remark Lock Doors & Arm System Panic function Press and Hold for 3 seconds Car Locator Under armed mode + Arm and Delete The 2 Stage Shock Sensor Silent Arming / Disarming Press twice within 3 seconds - Unlock Doors & Disarm System Two Steps Door Unlock & Disarm System Trunk Release (Channel 2) Press twice within 3 seconds. Passive Arming By -pass While the system Disarmed. - Ignition in "off" position.
PASSIVE ARMING: Active arming / disarming is controlling your security system via the remote transmitter. This security system is equipped with an optional Passive Arming feature, which allows the security system to arm 30 seconds after the last door is closed. Operation is as follows. 1. Turn the ignition to the “OFF” position and exit the vehicle. 2. After all entrances are closed, the security system LED will flash fast for 30 seconds.
PATHWAY ILLUMINATION: This feature turns the parking light “ON” for 30 seconds upon a unlock signal and for 10 seconds upon the lock signal if programmed. TWO STEP DOOR UNLOCK: This feature will independently unlock the driver’s door only when disarming the security system. Pushing the button on the transmitter a second time within 3 seconds will unlock the entire vehicle.
TRIGGER THE SYSTEM When armed, your vehicle is protected as follows: 1. Light impacts will trigger the warn-away signal. A long chirp from siren/horn. 2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition switch- All will trigger the programmed sequence. The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren and parking lights will turn on to alert of an intrusion for 30 seconds. Then the siren will stop and automatically reset and re-arm.
IGNITION CONTROL DOOR LOCKS. If the vehicle’s door locks have been interfaced to the security system, the system will automatically lock the vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is turned “OFF”. TRUNK RELEASE. Press and hold button on transmitter for two seconds to remote control the trunk release or other electric devices.
BATTERY REPLACEMENT: A 1.5V type AAA Alkaline battery powers the Remote Transmitter. When the power of the battery weakens a icon shall be displayed on the LCD screen. When the old battery is replaced to new one, there will be beep sounds indicate the power is up. Note: Press the button two times when the battery compartment is empty, and then insert the new battery.
PROGRAM MODE FOR LCD REMOTE CONTROL TRANSCEIVER: Transceiv er Button System Function Remark Switching code for 2nd / 1st Car Operation Press within 5 seconds Program Mode Melody / Vibration Mode Press within 5 seconds Program Mode Power Save Mode Press within 5 seconds Program Mode LCD screen lamp turns on for 5 seconds. System’s Status Check Press within 3 seconds + Clear the Flash Icon and Melody Sound Press within 3 seconds + 1.
Power Save Mode: While in the power save mode, the LCD remote transceiver will “sleep” until a button is pushed, to extend the life of battery. When power save mode is ON, the remote control will wake up periodically to check for messages from the security module. 1. Press and hold all four remote control buttons simultaneously unit one long beep is heard. Programming has now been entered. 2. Within 5 seconds, press the button to toggle “On” or “Off”. The remote will beep once for “On”, twice for “O f f ”.
ALARM OPERATING CONDITION : Function Siren 1. Arm 2. Disarm 3. Trigger 4. Panic 5.
LIMITED LIFETIME WARRANTY PROVISIONS ( U.S. ,Continental U.S. and Canada Only) 1. Auto Page, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery.
authorized by a dealer of Auto Page will void the product’s limited lifetime warranty. This WARRANTY CARD is for your record. However, AutoPage reserves the right to request you to submit this WARRANTY CARD which must have complete information to receive warranty service. Please keep this card in a secured place. AUTOPAGE WARRANTY SERVICE CARD Model: RF-420LCD Serial # _______________ CUSTOMER TO COMPLETE DEALER TO COMPLETE Mr./Mrs./Ms.
960 Knox Street Unit B Torrance, California 90502 Main Office: 310-323-1800 Customer Service: 800-262-2527 Ext. 462 www.autopageusa.