Installation Manual

15
CABLE GUIDE
Advanced Digital & Analog Lighting Controller
(APDPX2)
Fixtures are not shown to scale.
IMPORTANT: Do not attach data link cables to AC power cable. Always keep low voltage data cables and high voltage AC power harness as far as possible from each other for stable signal transmission. Avoid coiling data cables as well as AC harnesses in tight coils. Excess cable should be managed by creating long loops as opposed to tight coils.
RJ12 to USB
Data
Link Cable
RJ12
T-Connector
ZONE A Controls up to 50 LED fixtures. ZONE B Controls up to 256 HID fixtures.
Data Link Cable RJ12 T-Connector RJ12 to RJ12 RJ12 to USB
LEGEND: HPS, MH & CMH
LEGEND: LED Fixtures
PTB Link Cable PHOTO•LOC Cable
CHC882000B
Female end Male end T Connector
• For use with PHOTOBIO X, M, T, and T Duo • Includes 2 cables and 1 T Connector
1 Attach BLACK female end of the first
cable to the
ORANGE male end of the
PTB link cable (included with PX2).
2 Attach ORANGE male end of the
first cable to the
BLACK female
side of the T connector (trunk line).
3 Attach BLACK female end of the
second cable to the
ORANGE male
bottom of the T connector (branch line).
4 Attach ORANGE male end of the
second cable (branch line) to fixture.
5 Repeat steps 1–4 for each fixture.
PHOTO•LOC 0–10V Cable Kit CHC882000B (sold separately)
PTB
Link Cable
LED + DUAL CMH
Checkerboard