Installation Manual

8
INSTALLATION - PULL ARM
Remove the cover and endcaps of the rail. Keep the door fully closed. If installing onto right
hinged door, rotate the arm full to the left.
Slide the rail along the ball of the arm. Hold the
rail up to the door panel where it will mount.
The ball should be upwards in the rail.
Holding the rail in place, drill in the rightmost
screw.
Position the right edge of the rail an inch from
the ball when the door is fully closed
Open the door almost fully and drill in the left-
most screw, using the ball to keep the rail level.
The rail should be flush against the door panel.
1 inch