Operation Instructions

Jumper settings selection
 Single jumper must be always attached to allow relay operation. If removed, output signal is
disconnected.
 Double switch is used to select the relay contact type: Normally Open (NO) or Normally
Closed (NC). Position of each setting is as per illustration.
Erasing all Tags from Transmitter memory
1. Remove the top cover of the Transmitter.
2. Access the learning button with the pin or screw driver. Press the button and hold it for 10
seconds or until the red LED is Off.
Activating from outside the range
Tag can activate the relay even from outside detection range: pressing the button on theTag will
send activation signal to the transmitter.
Important notes
 Do not leave the Tag in activation range for long periods of time: it will drain the Tag’s
battery.
 The new Tag has a maximum range settings and will operate with maximum distance from
the Transmitter. If Tag was not added to the Transmitter’s memory, it will not activate the
Transmitter, but will still be sending activation messages which may drain the battery faster
than intended by normal operation. Make sure the Tag is outside the activation range or
battery is removed.