User guide

User Guide P. 3
Remote-starting Your Vehicle
If your vehicle has an automatic transmission, simply press the Ι button to remote start or the
ΙΙ button to stop your vehicle. Skip the next steps on to “Remote-starting”.
Warning: If your vehicle has an automatic transmission and the parking lights flash 15 times
after pressing the ΙΙ button, the parking brake is connected to ground. It is imperative that
you see your installer and have him disconnect the wire.
Setting Your Vehicle Into Ready Mode
If your vehicle has a manual transmission you must read the following indications. In order to
start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to
Ready Mode, it cannot remote-start the vehicle.
Once the system is set to Ready Mode, the vehicle can be remote-started and stopped at
wish.
To set the system to Ready Mode:
1. Ensure that all the doors are closed and that the shifter is in the NEUTRAL position.
2. With the engine already running, apply the parking brake and release the brake
pedal.
• Make sure to release the brake pedal.
3. Within 20 sec. press Ι or ΙΙ on the transmitter.
• The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a. ΙΙ to shut down the engine without affecting the doors.
b. Ι & ΙΙ to lock the door and activate idle mode.
NOTE: If button Ι is programmed as LOCK or UNLOCK, press and hold either
a. Ι to lock the doors and shutdown the engine or lock and enter turbo mode,
b. ΙΙ to shut down the engine without affecting the doors,
c. Ι & ΙΙ to lock the doors and activate idle mode.
Remaining In Ready Mode
Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However,
should any of the following occur, the vehicle will exit Ready Mode – thus eliminating the
remote start option until Ready Mode is restored:
• Door opened;
• Hood opened;
• Brake pedal pressed;
• Parking brake disengaged;
• Ignition key turned to the IGNITION ON (RUN) position.
Note: The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes
(parking lights).
Remote-Starting
Press the Ι button for approx. 1 second. The parking lights will come ON, informing you that
the unit has received your signal. Approx. 5 seconds later, the engine will start. The Parking
Lights will remain ON during the pre-programmed run time.
For manual transmission if the vehicle doesn’t start the first time, the system will shut down.
For automatic transmission if the vehicle doesn’t start the first time, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.