User guide

P. 4 User Guide
Driving Off
Enter the vehicle and do the following:
• Turn the ignition key to the IGNITION ON (RUN) position.
• Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Note: Press button Ι to
DISARM the module and to UNLOCK the doors (if button Ι is
programmed as
LOCK or UNLOCK button).
Caution: do not turn the key to the CRANK position with the engine running. This will cause
the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-
Grind Feature (Optional).
Remote starter features
Idle Mode
This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the
IGNITION switch. The vehicle will keep running for the pre-
programmed run time, or until it is shut down by remote.
Caution: Do not leave children or pets unattended in a car running in Idle Mode.
To activate Idle Mode:
To enable Idle Mode if your vehicle has an automatic transmission
, press and hold the
Ι button on your remote transmitter while the engine is running.
To leave the vehicle in Idle Mode if your vehicle has an automatic transmission:
1. While the engine is running, press the Ι button on the remote control until the
parking lights come on.
2. Remove the key and exit the vehicle. The engine will go on running.
Lock the doors (if button Ι is programmed as
LOCK or UNLOCK button).
If your vehicle has a manual transmission
, Idle Mode can be activated through the same
routine as that used for Ready Mode; at the last step, the Ι & ΙΙ button are pressed
together.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the
user leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds
(or until it is shut down by remote control), then shut down the engine.
Proceed as follows to set the system to Turbo Mode if your vehicle has an automatic
transmission:
1. With the engine already running, press the Ι & ΙΙ button on the transmitter until the
parking lights come ON.
2. Remove the ignition key from the ignition switch. The engine will go on running.
3. Exit the vehicle and close the door.
4. Press the Ι & ΙΙ button to lock the doors; the engine will shut down after 60
seconds of Turbo Mode.
Note: If your vehicle has a manual transmission
, Turbo Mode can be activated only if button
Ι is programmed as
LOCK or UNLOCK button. Turbo Mode is activated through the same
routine as that used for Ready Mode; at the last step, the Ι button is pressed.
Valet Modes
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine
from being remote-started accidentally.