User guide

P. 6 User Guide
To exit Cold Weather Mode, do any one of the following:
• Open the hood.
• Start the engine using the remote control.
• Turn the ignition key to the IGNITION ON (RUN) position.
• Press and hold the ΙΙ button for 3 seconds
(until the parking Lights flash once)
• Set the vehicle to Valet Mode.
Engine Run Time
(Gas 15 minutes, Diesel 20 minutes by default) If you have a gas engine, your system can
be programmed to run the engine for 3, 15, or 25 minutes (15 minutes by default). If you
have a diesel engine, it can be programmed to run the engine for 8, 20, or 30 minutes).
Advanced Features: Installation-programmable options
Note: The programming of these features should be left to a professional. Changing any
one of the settings may adversely affect the operation the Module.
Arming the Starter Kill
Note: It can only be activated if button Ι is programmed as
LOCK or UNLOCK button.
If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm
automatically) or in Passive Mode (will arm automatically).
• To disarm the Starter Kill in Active or Passive Mode, press the Ι button on the transmitter.
The parking lights will flash twice. (If Remote Door Locks were installed, this will also un-
lock the doors.) In Passive Mode, the system will automatically rearm 1 or 3 minutes after
the doors were unlocked.
• To arm the Starter Kill in Active or Passive Mode, press and hold the Ι button on the
transmitter. The parking lights will flash once. (If Remote Door Locks were installed, this
will also lock the doors). In Passive Mode, the system will automatically arm 1 or 3 minutes
after the engine is shut down.
Remote Door Locks
Note: It can only be activated if button Ι is programmed as
LOCK or UNLOCK button.
If your system was installed with the Remote Door Locks option, you will have the
convenience of remote keyless entry.
To lock your doors and arm the starter kill:
1. Press and hold the Ι button for approx. 1 sec.
2. The parking lights will flash once and the L.E.D. will flash slowly to confirm that the
doors have been locked and that the Starter Kill feature is enabled if it was installed.
To unlock your doors and disarm the starter kill:
1. Press and hold the Ι button for approx. 1 sec.
2. The parking lights will flash twice and the L.E.D. will go out to confirm that the doors
have been unlocked and that the Starter Kill feature is disarmed if it was installed.
Note: If installed and configured in passive mode at installation, the starter kill feature will
rearm automatically 60 seconds after the doors are unlocked. For that reason, you may
have to unlock your doors a second time if some time elapses before you actually start
the engine.