User guide

ManualsBrandsAutostart ManualsAutomotiveAS-2360TW

MANUAL TRANSMISSION REMOTE STARTER

AS-2360TW

User Guide

Table of Contents

Table of Contents...................................1

Introduction.............................................1

Using the Remote Control......................2

Feature Confirmation Chart....................3

Vehicle Status Request..........................3

Status Request When the Engine IS NOT

Running..................................................4

Ready Mode Status Request..................4

Status Request When the Engine IS

Running..................................................5

How Run Time Cycles Work...................6

Multi-Level Features (default state).......6

Remote-Starting Your Vehicle................7

Setting Your Vehicle into Ready Mode...7

Remaining In Ready Mode.....................8

Remote-starting......................................8

Vehicle Presets.......................................8

Driving Off...............................................8

Using the Remote Car Starter................9

Arming the Starter Kill.............................9

Idle Mode................................................9

Turbo Mode............................................9

Valet Mode............................................10

Valet Mode Using the Valet Switch (if

installed)...............................................10

Ignition Valet.........................................10

Remote Valet Mode..............................10

“Home Valet

” Mode...........................11

Panic Mode...........................................11

Quick Lockout

....................................11

Cold Weather Mode..............................11

Advanced Features: Installation-

programmable Options.........................12

Remote Door Locks..............................12

Priority Door Access.............................12

Active or Passive Arming......................12

The Starter Kill and the Anti-grind Feature

..............................................................12

Flashing LED........................................12

Safe Start..............................................13

Ignition-controlled Door Locks..............13

Ignition Re-lock.....................................13

Secure Lock..........................................13

Turbo Mode..........................................13

Remote Trunk Release.........................13

Engine Run Time..................................14

Extended Run Time..............................14

Multi-car Operation...............................14

Troubleshooting Poor Transmitting Range

..............................................................14

Diagnostics – Parking Light Flash Table15

Introduction

This is a state-of-the-art remote car starter system. The system is packed with advanced features

such as priority access to the driver’s door (commodity features) and the Safe Start children safety

feature. With many an advanced function, this product will satisfy any one your expectations from

high-end commodity and security systems, without neglecting any standard feature commonly

offered by entry-level starters.

DOC:.1.11– September 23, 2004 CA Manufactured in Canada

Summary of content (15 pages)

PAGE 1
MANUAL TRANSMISSION REMOTE STARTER AS-2360TW User Guide Table of Contents Table of Contents ................................... 1 Introduction............................................. 1 Using the Remote Control ...................... 2 Feature Confirmation Chart .................... 3 Vehicle Status Request .......................... 3 Status Request When the Engine IS NOT Running .................................................. 4 Ready Mode Status Request..................
PAGE 2
INDUSTRY CANADA USER NOTICE: Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for successful communication. FCC USER NOTICE (U.S.A.
PAGE 3
Feature Confirmation Chart Feature LED #1 LED #2 LED #3 LED #4 Beep(s) Lock 3 flashes X X X 1 Unlock X 3 flashes X X 2 Trunk X X 3 flashes X 1 LED ON/OFF 3 flashes 3 flashes X X 1 Start X X X 3 flashes 1 Running X X X 3 flashes 3 Stop X X X 3 flashes 2 Entering Cold Weather Mode X X X 3 flashes 2 Exiting Cold Weather Mode X X X 3 flashes 1 Home Valet 3 flashes X X 3 flashes 2 Valet Mode 3 flashes X X 3 flashes 1 Exit ValetMode X 3 fla
PAGE 4
Status Request When the Engine IS NOT Running STATUS Lock Unlock Cold Weather SEQUENCE LED #1 3 flashes X LED #2 X 3 flashes LED #3 X X LED #4 X X Beep(s) 1 2 1st sequence if locked 3 flashes X X X 2 1st sequence if unlocked X 3 flashes X X 2 2 sequence X X X 1 second X 1st sequence if locked 3 flashes X X X 2 1st sequence if unlocked X 3 flashes X X 2 nd Home Valet Valet Mode 2nd sequence 1 second X X 1 second X 1st sequence if locked 3 flashes X X X 1 1s
PAGE 5
Status Request When the Engine IS Running When the vehicle’s doors are locked: RUN TIME If there is more than 3/4 of run time cycle If there is more than half of run time cycle If there is more than 1/4 of run time cycle If there is less than 1/4 of run time cycle SEQUENCE LED #1 LED #2 LED #3 LED #4 Beep(s) 1st sequence 3 flashes X X X 3 ON for 1-sec X X 3 X X X X 3 X X X 2nd sequence ON for 1-sec ON for 1-sec ON for 1-sec 1st sequence 2nd sequence 3 flashes X ON for 1-sec ON
PAGE 6
How Run Time Cycles Work RUN TIME CYCLE LED #1 will turn itself off when ... LED #2 will turn itself off... LED #3 will turn itself off ... LED #4 will turn itself off... 4-minute run time cycle ... the cycle will have ended. ... 3 minutes into the cycle. ... 2 minutes into the cycle. ...1 minute into the cycle. 9-minute run time cycle ... the cycle will have ended. ... 7 minutes into the cycle. ... 5 minutes into the cycle. ... 3 minutes into the cycle. 15-minute run time ...
PAGE 7
By default, the multi-level features are programmed as follows: x Level 1 (Basic Features) x Level 2 (Multi car operation) x Level 3 (Customized Features) x To access a feature that is programmed as level 1, press the SHIFT button once followed by the desired function. x To access a feature that is programmed as level 2, press the SHIFT button twice followed by the desired function. x To access a feature that is programmed as level 3, press the SHIFT button three times followed by the desired function.
PAGE 8
To set the system to Ready Mode: 1. Ensure that all the doors are closed and that the gear selector is in the neutral position. 2. With the engine already running, apply the parking brake and release the brake pedal. Make sure to release the brake pedal. 3. Within 20 sec. press LOCK, UNLOCK or START/STOP on the transmitter. The parking lights will flash 3 times quickly and remain lit. 4. Remove the key: the engine will go on running. 5. Exit the vehicle and close the door. 6. Press and hold either: a.
PAGE 9
You are now ready to drive off. Using the Remote Car Starter Arming the Starter Kill The Starter Kill (if installed) can be configured by the installer so as to arm automatically (Passive Mode) or not to arm automatically (Active Mode). See section Passive or active arming, later in this guide, for more details on Passive Mode and Active Mode. • To disarm the Starter Kill, press the UNLOCK button on the transmitter. The parking lights will flash twice.
PAGE 10
4. 5. 6. The parking lights will flash 3 times quickly and remain lit. Remove the key: the engine will go on running. Exit the vehicle and close the door. Press and hold either: a. LOCK to lock the doors and shut down the engine after 60 sec.; b. UNLOCK to unlock the doors and shut down the engine after 60 sec.; c. START/STOP to shut down the engine immediately, without affecting the doors (this will by-pass Turbo Mode). D.
PAGE 11
• Hold the UNLOCK and START/STOP buttons simultaneously for 3 second. • The Parking Lights will flash 2 times. The LED will turn off. “Home ValetTM” Mode If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if the vehicle is parked indoors there is no danger of it starting accidentally by remote control. Note: Once the Home Valet Mode is activated, the vehicle will not start by remote. To take the system i n t o Home Valet Mode: • Press the LOCK button.
PAGE 12
• Press the brake pedal. • Press and hold the START/STOP button for 3 sec. (the parking lights will flash once). When the vehicle exits Cold Weather Mode, the Parking Lights will flash once.
PAGE 13
• Flashing LED ON: the L.E.D. will flash at all times (either under active arming or under passive arming) to indicate that the starter kill is active. • Active Arming: the LED will flash normally. • Passive Arming: the LED will not flash during the countdown preceding the activation of the Starter Kill. Once the Remote Car Starter is armed, the LED will flash at a normal rate. • In Valet Mode: the LED will remain lit without flashing.
PAGE 14
Engine Run Time If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 4, 15, or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be programmed to run the engine for 9, 20, or 30 minutes (20 minutes default). Extended Run Time With the vehicle running under a remote start, pressing and holding the START/STOP button for more than 1 second will reset the run time counter to zero and restart the run time cycle from the beginning.
PAGE 15
Diagnostics – Parking Light Flash Table Flashes 1 2 3 4 5 6 8 10 1 – pause – 2 2 – pause – 2 Description • • • • • • • • • • • • • • • • • • • • • • • • 4 – pause – 3 • 10 – pause – 3 • • ON 2 sec. ON 3 sec. ON 4 sec. • • • ON 25 sec. • Irregular Constant flashes up to 30 sec. Doors locked, Starter Kill armed. End of Run Time. TRUNK button pressed Start signal received by the Remote Car Starter. Cold Weather Mode cancelled. Cannot start after maximum number of attempts is reached.