User guide

P. 10 AS-2360TW User Guide
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a. LOCK to lock the doors and shut down the engine after 60 sec.;
b. UNLOCK to unlock the doors and shut down the engine after 60 sec.;
c. START/STOP to shut down the engine immediately, without affecting the doors
(this will by-pass Turbo Mode).
D. TRUNK TO SET THE VEHICLE INTO IDLE MODE
Valet Mode
When your vehicle is in valet mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the valet mode will prevent the engine from being
remote-started accidentally.
When the vehicle is set to valet mode, the LED remains ON (it does not flash). The LED will
turn itself off ONLY
when the ignition key is turned to the IGNITION ON position.
Valet Mode Using the Valet Switch (if installed)
To put the system i n t o Valet Mode:
• Turn the ignition key to the IGNITION ON (RUN) position.
• Within 3 sec., press the valet button, the parking lights will flash three times and the
L.E.D. will come on solid once the ignition key is removed.
To take the system o u t o f Valet Mode:
• Turn the ignition key to the IGNITION ON (RUN) position.
• Within 3 sec., press and release the valet button , the parking lights will flash twice
the L.E.D. will turn itself off.
Note: Once Valet Mode is activated, the remote starter and alarm functions will be disabled.
Ignition Valet
This feature will allow you to remotely put your system into Valet Mode by using the ignition key
instead of the Valet button as above. Ignition Valet can be used without a Valet button installed.
To put the system i n t o Valet Mode:
• Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION ON / RUN and OFF positions.
• The parking lights will flash three times to indicate that the vehicle is now in Valet Mode.
The L.E.D. will come ON solid once the ignition key is removed.
To take the system o u t o f Valet Mode:
• Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION ON / RUN and OFF positions.
• The parking lights will flash twice to indicate that the vehicle is now in Valet Mode.
The L.E.D. will go out.
Note: With the Remote Valet activated, the remote starter and alarm functions will be disabled.
Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the Valet button as above.
Getting into Valet Mode
• Hold the UNLOCK and START/STOP buttons simultaneously for 3 second.
• The Parking Lights will flash 3 times.
The LED will remain on solid.
Getting out of Valet Mode