Installation manual

Operation SIMDOS diaphragm metering pump
KNF Flodos BA_SIMDOS_EN_02_160044.docx
28 Translation of original operating manual
7.18. Auto start
The “Auto start” setting defines the process for switching on the
pump.
Input Meaning
Off Pump does not start automatically when the
power supply to the pump is switched on.
On Pump starts automatically when the power
supply to the pump is switched on.
Tab. 15: Autostart
When the “Autostart” option is on, this is indicated in the main
display with the “AS” symbol (see Fig. 43).
CAUTION
If Autostart is on, the pump will start operating as
soon as the power supply is switched on.
There is a potential risk of injuries or damage to
equipment from media spillages if the pump is
activated without warning.
 Activate the Autostart option only when
equipment is ready for use.
 Clearly identify the fact that the Autostart option
for the pump has been activated.
 Before start-
up, check that hoses and equipment
are tight-sealed and correctly connected.
If you want the pump to respond automatically to external signals
as soon as the power supply is switched on, you may activate the
Autostart option.
System 
Fig. 41: Autostart
Fig. 42: Autostart symbol in display
Autostart and external drive