Installation manual

SIMDOS diaphragm metering pump Operation
KNF Flodos BA_SIMDOS_EN_02_160044.docx
Translation of original operating manual 29
7.19. Contrast
This refers to the contrast setting for the display. Adjust the
contrast if the display is poorly legible.
7.20. Reset
The “Reset” function is used to reset the pump to its factory
settings.
Input Meaning
No No reset
Yes Pump is reset to its factory settings
Code No function
Tab. 16: Reset
The reset function will restore the following settings:
Value Setting = factory setting
Flow rate [ml/min] 10.0
Unit ml/min
Time counter Off --min -- sec
Fluid type Standard
Calibration 100%
Language English
Analogue input Off
Digital input 1 Off
Digital input 2 Off
Digital output Alarm
Autostart Off
Contrast 40
Tab. 17: Reset factory settings
System 
Fig. 43: Contrast
System 
Fig. 44: Reset