User's Manual

User Guide P. 13
3
• Entering cold weather mode.
• Entering extended run time.
• Entering remote valet
• Entering ignition valet
• Disabling LED
4
• +12 V where detected on the brake line and cranking was cancelled.
• Entering tach-programming mode
5
• New transmitter programmed.
• Tach programmed.
6 • A remote start was attempted while a tach or a vacuum signal was detected before cranking.
8 • Unit reset: occurs when the unit is reset to the factory defaults.
10 • The hood switch line went to ground during cranking or run time.
1 – pause – 2 • There was an attempt to start the vehicle while the module was in valet mode.
ON solid • Cold weather mode: the brake pedal is being held down.
2 – pause – 2 • There was an attempt to start the vehicle while the module was in home valet mode.
ON 2 sec.
• The hood is up and the hood switch line went to ground. This is step one of the programming
centre procedure.
ON 3 sec. • First press of the START button under safe start.
ON 4 sec. • Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 25 sec.
• The hood pin-switch has been pressed twice: the unit went into step 1 of the programming
centre procedure, and no transmitter activity was detected for 20 seconds.
• Or the unit went into step 1 of the transmitter programming procedure and no activity was
detected for a few seconds. The unit has exited the transmitter programming procedure.
Irregular
• If the unit gives irregular signals (1 to 10 flashes followed by a pause, followed by further
flashes), the system is playing back start failure codes. This occurs when the hood pin-
switch is pressed three times
Constant flashes
up to 30 sec.
• Panic mode is triggered.