User's Manual

P. 16 User Guide
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine, to
activate Turbo Mode:
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. press , or on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a. to lock the doors and shut down the engine after 60 sec.;
b. to unlock the doors and shut down the engine after 60 sec.;
c. to shut down the engine immediately, without affecting the doors
(this will bypass Turbo Mode).
d. TO SET THE VEHICLE INTO IDLE MODE
Engine Run Time
If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
How to Access to Run Time Status
(Indication purpose only)
Function By pressing Icon Gasoline Diesel
3 minutes 8 minutes
Engine runtime
15 minutes 20 minutes
25 minutes 30 minutes
Temperature Request (If ACC-Temp-101 installed)
The user can request the temperature in the vehicle if a Temperature Sensor Module (ACC-Temp-
100) is installed:
o Press the
button for 1 second and release; you will hear a beep. L-01 will appear
on the screen.
o Immediately press the
button and hold it until the temperature is displayed on the
LCD screen.
Note: to change the temperature from Celsius to Fahrenheit, the user needs to refer to the menu.
Horn Chirp Timing
The pulse duration can be configured by your installer (from 5 ms. to 200 ms.).
Pager Function
This function will help you find the remote. By pressing the valet button for 3 seconds, you will
trigger the pager function. The remote will beep to inform you of its location. User can press the
LOCK or UNLOCK button to stop the beeping of the remote once it is found.
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same remote starter model, to
control both systems independently with a single remote control. To control the second vehicle: