User's Manual
User Guide P. 21
Diagnostics – Parking Light Flash Table
Flashes Description
1
• Doors locked, Starter Kill armed.
• Run time has expired.
• TRUNK button pressed.
• Start signal received by the module.
• Cold Weather Mode cancelled.
2
• Remote start attempt cancelled by
remote.
• Doors unlocked, Starter Kill disarmed.
• Exiting Ignition Valet.
• Exiting Remote Valet.
• Power-up reset.
• Board set from manual to automatic;
power ON.
• Power ON to OFF (automatic
transmission).
2 quick flashes
continuously
• Starter Kill ON / Alarm OFF.
3
• Entering Cold Weather Mode.
• Extended run time.
• Entering or exiting Ready Mode.
• Entering Ignition Valet.
• Entering Remote Valet.
• Disabling LED.
3 slow flashes… …after a failed start attempt. The module did not detect a tach signal.
4
• +12 V detected on the brake input wire either while cranking or during run time.
• Entering multi-speed tach programming.
• Board set from automatic to manual; power ON.
• Power ON to OFF (manual transmission).
5 Slow • Start attempt failed because no tach signal has been programmed.
5 Fast • Tach signal programmed.
6
• A remote start was attempted while a tach-before-crank signal was detected before
cranking.
8 • Unit reset: occurs when the unit is reset to the factory defaults.
10 • A ground (-) signal was detected on the hood pin input wire.
When pressing
START/STOP
15 quick flashes…
• The parking brake is connected to ground (automatic transmission).
1 pause
1pause
5 flashes
• Transmitter has been programmed.
[During the transmitter programming procedure.]
1 – pause – 2
• There was a remote start attempt while the vehicle was in Valet Mode.
• Failed start: vehicle’s low battery voltage.
…followed by 1 flash. Exiting Cold Weather Mode.
ON SOLID for 3
seconds….
…followed by 3 flashes. Entering Cold Weather Mode.
ON continuously
• Idle Mode: Idle Mode is engaged.
• Run time: The vehicle has been remote started and is in run time.
ON continuously
While the
brake pedal
is pressed.
• Confirms that Cold Weather Mode is engaged.
ON 2 seconds
• The hood has been opened and a ground (-) signal has been detected on the hood
pin input wire.
ON 4 seconds • Locking or unlocking a door (with Door pulses configured to 4 sec.).
ON 20 seconds • The hood pin has been flashed and you are now in the programming centre.
Constant flashes
for 25 sec.
• Panic Mode is triggered.