User's Manual

2
WHAT’S INCLUDED
Please review the installation guide before
beginning the installation, particularly the
wiring diagram and the list of programming
options.
Prior to installation please be sure that all
hardware components required to install the
system are in the box.
The following is a list of components included
in the Kit:
• 1 - Control unit
• 1 – Transmitter (As per model)
• 1 - 5 Pin 14 AWG harness (Ignition
harness)
• 1 - 7 Pin 18 AWG harness (Main harness)
• 1 - 4 Pin / 2 Wire 18 AWG harness
(Accessories)
• 1 Antenna
• 1 Parts Bag (hood switch, valet switch,
connector, wires)
• User guide, tech bulletins.
NOTICE:
THE MANUFACTURER IS NOT
RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
INSTALLATION POINTS TO
REMEMBER
• When working on a vehicle always leave a
window open.
• Remove courtesy light fuse if possible to
prevent battery drain.
• Never Install control unit where it could
interfere with normal operation or obstruct
service technicians.
• Do not disconnect the battery on vehicles
equipped with air bags and anti-theft
radios.
• Always use a grommet when running
wires into the engine compartment. Never
run wires through bare or sharp metal.
• Always solder and tape all connections.
• Never ground control unit to vehicle
steering column.
• Make sure that vehicles equipped with
automatic transmission do not start while
in any of the drive gears. *(If it will start
in gear please install a manual
transmission starter)
FEATURES
 Dual 12 volt power lines.
 12 volt parking light output.
 Multi channel transmitter. (AS-1203/04
Only)
 Multi car operation. (AS-1203/04 Only)
 Factory alarm control.
 Electronic Valet Mode (AS-1202 Only)
 Gasoline or Diesel engine ready.
 Negative door lock output.
 Cold weather timer.
 Negative trunk output.
 Up to 1500 feet range.(SH models only)
 Ground output (pulsed or constant)
 Starter kill out (Ground when armed)
 External trigger control (From external
receiver. e.g.: alarm)
OPTIONS
• Remote keyless entry
• Remote Trunk release
• Engine kill
• Flashing LED
• Pager Ready
• 2 YEAR LIMITED WARRANTY
PROGRAMMABLE OPTIONS
• Door lock pulse duration ( 1 sec, 4 sec,
or two ¼ sec unlock pulses).
• Ignition controlled door locks.
• Constant or pulsed Groundout when
running.
• Run time (5,15, or 25 minutes)
• Maximum crank duration (6,8, or 12
seconds).
• Childproof operation.
• Gasoline or Diesel engine operation.
VALET MODE (AS-1202 ONLY)
The AS-1202 system ONLY is equipped with an
electronic valet mode. The Electronic Valet
Switch works only with the ignition key turned
to the RUN position, so the vehicles key must be
present to place the system IN or OUT of Valet
mode.
In order to place the unit INTO valet mode
you must do the following:
1- Turn ignition key to the “ON” position
(Wait 3 sec)
2- With key ON, turn Valet switch to the “ON”
position. (Wait 3 sec)
3- Now L.E.D should be on solid
4- Turn ignition key OFF (system should now
be in valet)If L.E.D is not on constant than
repeat steps 1 to 4.