User's Manual

4
CUSTOM PROGRAMMING OPTIONS
Autostart systems are equipped with 2 custom
programming menus that allow the user to
custom fit the system according to the
installation requirements.
These options are designed to help make
interfacing with all vehicles possible.
To get into custom programming mode you
must do the following:
1. Hold pinswitch down for 6 sec.
2. Release pinswitch (parking lights will come
on)
3. Immediately push and release pinswitch
once again. (parking lights will stay on for
20 sec.)
4. Press and hold brakes, and press 1 or 2
on remote transmitter. (Button 1 for
mode one, and Button 2 for mode two)
(lights will flash once for mode 1 and twice
for mode 2)
After you have entered into one of the two
programming menus you can release the
brake pedal. The unit will stay in programming
mode until the hood pinswitch is pressed or
the valet switch has been turned off. (so take
your time to make the proper selection)
The menu will automatically start you at
function one, once you choose from one of the
three Options, you will automatically jump to
the next function.
To select one of the three options press the
appropriate transmitter button. (see below)
1. Button 1 = Option 1
2. Button 2 = Option 2
3. Button 1 & 2 = Option 3
Once an option has been selected the parking
lights will flash 1,2 or 3 times. (Depending on
option selected)
MODE 1
*INDICATES DEFAULT SETTING
FUNCTION 1
OPTION 1* Ignition Lock ON
OPTION 2 Ignition Lock OFF
OPTION 3 Ignition Lock ON and locks in
TOGGLE MODE*
*DOOR LOCK TOGGLE MODE
Autostart has a built-in starter kill feature and
even if the starter kill is not installed, the logic
for it still dominates the operation of the
system. What this means is that the starter kill
will arm automatically 45 seconds after the
vehicle’s ignition is turned “OFF”. The
vehicle’s starter wire is then interrupted until
the starter kill is disarmed by pressing button
1 (unlock) on the remote. If the doors were
not locked within the initial 45 seconds of the
ignition being turned “OFF” the first press of
button 1 will disarm the starter kill, unlocking
the already unlocked doors before they can
be locked again, arming the starter kill.
Enabling Toggle Mode will circumvent this
logic and allow the doors to lock on the first
press of the button regardless of how much
time has elapsed since the ignition was
turned “OFF”. This means that when the
door lock will always perform the opposite of
the last remote door lock action.
FUNCTION 2
OPTION 1* Constant “GROUNDOUT”
OPTION 2 Pulsed “GROUNDOUT”(1
sec)
OPTION 3 Constant “GROUNDOUT”
with disarm pulse on defrost
line (pin # 15)
FUNCTION 3
OPTION 1* .75 second door lock /
unlock pulses.
OPTION 2 4 second door lock / unlock
pulses.
OPTION 3 One 1 second lock pulse
and two ¼ second unlock
pulses.
FUNCTION 4
OPTION 1* Trunk release on channel 3
(will not receive signal while
ignition is “ON”)
OPTION 2 Garage door transmitter
control (will receive signal
with Ignition “ON”)
OPTION 3 Channel 3 used for
activation / deactivation of
cold weather mode.
FUNCTION 5
OPTION 1* External trigger disabled
OPTION 2 External trigger enabled
OPTION 3 Child proof Operation
(Transmitter button must be
pressed for 4 seconds)
MODE 2
* INDICATES DEFAULT SETTING
FUNCTION 1
OPTION 1 5 minute run time
OPTION 2* 15 minute run time
OPTION 3 25 minute run time