User Manual

Procedure:
1. Raise rear of car with floorjack and place jackstands under car using factory lifting and support locations.
(Figure 1)
2. Remove the nuts that attach the end-links to the factory swaybar. (16mm. Box wrench & 5mm. triple
square socket) (Figure 2)
3. Loosen and remove the bolts holding the swaybar bushing bracket (8mm. triple square socket)
4. Remove OEM swaybar w/ brackets and bushings
5. Grease the inside of the Autotech supplied bushings and slide them onto your new swaybar. (Waterproof
Moly Grease) (Figure 3 & 4)
6. Attach swaybar endlinks to new swaybar with the nuts finger tight. (Adjustment Chart)
7. Swing swaybar up near the subframe and install brackets over bushings. (Figure 5)
8. Tighten the bracket bolts.
9. Tighten endlink nuts.
10. Lower car onto ground.
Installation Instructions
Part Number: 10.525.1825K
Description: Mk5 Adjustable Rear Swaybar Kit Instructions
TOOLS REQUIRED: PARTS LIST:
1. 8mm. triple square socket 1. 25mm. Tubular Mk5. Front swaybar
2. 16mm. box wrench 2. Powdercoated swaybar bushing brackets
3. 5mm. triple square socket 3. Urethane Mk5 Swaybar bushing
4. Jackstands 4. Die Cut “AUTOTECH” sticker – white
5. Floorjack
Softest
Middle
Stiffest