User Manual

PAGE 1
PAGE 2
Tintype Rubbing Eli Sie FOE Asian Calibration Strew: Mal Priers Assembly Operation steps: Step Open daylight plate, and place 2-3 drops of distilled water on the main prism. Close the daylight plate so the water spreads across the entire surface of the prism without air bubbles or dry spots. Allow the samples to temperature adjust on the prism for approximately 30 seconds before going to step #2.
PAGE 3
Stops Look in the eyepiece and tum the calibration screw until the boundary between the upper blue field and the lower whits field Is exactly on the zero scale as shown In the picture. This Is the end of the calibration process. Aka sure that the ambient room temperature matches the solution you are using When the working temperature of the part or environment (not that of the sample} changes by more than recommend that you calibrate to Malian accuracy.