Owners manual

3
1
Page 2 of 3
Installation Steps
4
Clean the door’s painted surface & the front-
mirror cap where the visor will attach.
2
free end
Remove the tape liner from the rear flanges. Peel back
2” of tape liner from each end of top flange.
Slide deflector forward so foam seal compresses against
mirror edge. Attach the top and rear flanges to the door’s
painted surface. Remove tape liner by pulling on free
ends.
Apply pressure to top and rear tape flanges to secure.
top flange
rear
flange
black
foam
4 Piece Set
The rear visor attaches with same preparation methods as the front visor.
Attach visor to the vehicle’s painted surface.
5
OR
NOTE: Actual application may vary slightly from illustrations.