Owners manual

3
1
Page 2 of 3
Installation Steps
4
Clean the door’s painted surface where the
visor will attach.
2
free end
Remove the tape liner from the rear flange. Peel back
2” of tape liner from each end of top flange.
Attach the top and rear flanges to the door’s painted
surface. Remove tape liner by pulling on free ends.
Apply pressure to top and rear tape flanges to secure.
top flange
rear
flange
4 Piece Set
The rear visor attaches with same preparation methods as the front visor.
Attach visor to the vehicle’s painted surface.
5
OR
NOTE: Actual application may vary slightly from illustrations.