User Manual

DVR

RearCamera

Cable arrangement

For safety, make sure you do this while the car is turned off. Lastly, please poke

the red positive bare wire through the positive reverse light wire and then wrap

with an electrical tape.

After connecting the red lead, it will have the reverse assist function.

Cable arrangement

Please arrange the cable as below

Step 5: Connecting the red wire with the

reverse light wires.

Reverse light wires are normally located

on the rear side of your car although their

placement may vary so be sure to refer to

your car’s manual. Once spotted, Use a

pair of pliers or wire stripper to peel the

rubber to expose the live wire.

Step 6: Route your rear camera's power

cable to the front of the car.

If you'd like, use a trim removal tool to

pop out the headlining panel directly

above your windshield. Then, run your

cable through the exposed chamber.

Step 7: Power on the dash cam with box

included car charger, don't charge it with

your own chargers.

Step 8: Test the camera to make sure

everything works.