AVL58 5.8G Video Link User Manual V1.
Disclaimer Thank you for purchasing this product. Please read the instructions carefully before installing the hardware and software for this product, this will ensure trouble free operation of your Video Link RX and TX. Please use this product in accordance with the provisions of your local authorities and regulations. Contents Disclaimer.............................................................................................................................................. 2 Contents ................
Contents 5. 8GHz Video Link Transmitter (TX) ×1 Analogue modulated video signals will be sent wirelessly by the TX module, working in the frequency band of 5.8GHz with 8 channels. 5.8GHz Video Link Receiver (RX) ×1 Connect to a display screen. The signal will be demodulated and sent to the display by the RX module, working in the frequency band of 5.8GHz with 8 channels. Antenna ×2 Optional, please make purchase according to your need.
Installation STEP1. Please assemble two antennas to the Video Link Transmitter and Receiver. STEP2. Connect the Video Link Transmitter to a video input source, and then connect the Video Link Receiver to a display screen and battery. STEP3. Make sure the Video Link Transmitter and Receiver are working on the same channel by using the channel-selection button; refer to the LED indicator flash pattern. Video Input Source Antenna Battery AVL58 5. 8G Video Link (3S~6S) 调频按键 RECEIVER RX 5.
Specification Performance Parameter Outdoor/RF Line-of-Sight Range 1.0 km Transmit Power 500mW Receiver Sensitivity (1%PER) -90dBm 2dBm CH1-CH8 Frequency Band CH1：5705MHZ CH5：5885MHZ CH2：5685MHZ CH6：5905MHZ CH3：5665MHZ CH7：5925MHZ CH4：5645MHZ CH8：5945MHZ Physical Parameter Operating Temperature -20~70oC TX: 50cm(length)X30cm(width)X22cm(height) RX: 55.5cm(length)X48cm(width)X17cm(height) TX: 39g RX: 49.
Trouble Shooting No. What Why How to Power supply is There is problem with the video OK, but no video input. 1 Please check the video input. Make sure RX and TX modules are The RX and TX modules are not 2 No video on the same channel by using the set to the same channel. channel-selection button. 1. The video mode of the display Video is flashing screen sets incorrectly. 1. Reset the video mode of the display screen. 3 and rolling. 2. The RX and TX modules are not set to the same channel.
