User manual

4
Installation
STEP1. Please assemble two antennas to the Video Link Transmitter and Receiver.
STEP2. Connect the Video Link Transmitter to a video input source, and then connect the Video
Link Receiver to a display screen and battery.
STEP3. Make sure the Video Link Transmitter and Receiver are working on the same channel by
using the channel-selection button; refer to the LED indicator flash pattern.
TX
RX
RX Knowledge
· Battery can apply power for both the RX module
and the display screen with an input voltage range of
3S.
· Video Output Port transmits video signal,
connected to the display screen.
· Chanel-Selection Button, which is for RX wireless
channel selection.
· LED indicates the RX working channel .
调频按键
TX Knowledge
· Video input port is A 8-pin Port. The
TX transmits both channel control signal
(CH1, CH2, …CH8) and video signal. Make
sure the connection of the port is correct.
· Chanel-Selection Button, which is for
TX wireless channel selection.
· LED indicates the TX working channel .
Antenna
Battery
Display Screen
Antenna
Video
Input Source
Battery
(3S~6S)
AV L 58
TRANSMITTER
5.8 G Vi d e oLi n k
5.8 G Vi d e oLi n k
RECEIVER
AV L 58
！
Important:
 The antenna MUST be connected before power on, otherwise electronics damage may occur.
 When use a battery to supply power for the RX and the display screen, the battery voltage must
not be higher than the input voltage of the display screen; otherwise damage may occur to your
display screen.
 Ensure there is no obstacle between antennas; otherwise the communication range will be reduced.
LED Indicator
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
Red LED blinks once after pressing the channel-selection button, indicating successful selection.