User manual

http://www.avacomtech.com
Avacomtech Inc.
Page 17
3.3.2 Mail Service Settings
Figure 18 Mail service settings
When the camera enters the alarmed state, it can send an email to your preconfigured
email address. The sender needs to support SMTP. You can get the supported SMTP
port from your email service provider. After configuring, click “Submit” to save these
parameters, and then you can click “Test” to check if the settings are successful.
When you have set the email service parameters correctly, you can click “enable “Report
Internet IP by mail”. After every restart, the device will send its Internet IP address to the
configured email address. You can use the IP address to visit the device if it was mapped
to the internet.