User's Manual

PAGE 13
Technical support [phone] www.avalanwireless.com
MOD090-HP
User’s Manual
RFState: When set this bit indicates that the RF is currently connected.
Radio: Indicates what mode the radio is in, when set it is in active mode. When
clear the RF is in standby mode.
CH3..0: Indicates what channel the RF is currently using.
The setStatus command is used to place the module in standby mode/normal
operation and to set the RF into manual channel mode by assigning a specic
channel.
setStatus SPI Mode:
0x81
UART Mode:
0x80
Byte 1 b7 b6 b5 b4 b3 b2 b1 b0
- Radio - - CH3 CH2 CH1 CH0
Radio: Setting this bit places the radio in active mode, clearing it places it in
standby mode.
CH3..0: When these bits are cleared the radio is in automatic channel mode. When
any of these bits are set the radio will be in manual channel mode and use the
channel indicated by these bits if it is valid.
Channel Frequency - MHz
1 904.4
2 905.6
3 906.8
4 908.0
5 909.2
6 910.4
7 911.6
8 912.8
9 914.0
10 915.2
11 916.4
12 917.6
13 918.8
14 920.0
15 921.2
16 922.4
17 923.6
18 924.8
19 926.0