AW5800mT User’s Manual Point-to-multipoint Industrial-grade, ultra-long-range 5.
AW5800mT User’s Manual Line-of-sight :: 5.8 GHz AW5800mT OEM Module Thank you for your purchase of the AW5800mT multipoint wireless Ethernet module. 5.8 GHz line-of-sight, point-to-multipoint radio transceiver module. Includes: n — (1) AW5800mT RF module — RPSMA female n — (1) AWP8 8-inch pigtail — RPSMA male — (1) to RPTNC bulkhead female If you have any questions when configuring your AvaLAN system, please send an e-mail to support@avalanwireless.com.
User’s Manual AW5800mT Continued from Page 2 SUs that have not yet received a network key boot up in “key exchange mode” and wait to receive a key. SUs that have received a network key will boot up for 5 seconds in “key exchange mode” and will look to see if a new AP is present. If a new AP is present, then the SU exchanges keys with the AP, otherwise the SU begins normal operation after the 5 seconds.
AW5800mT User’s Manual LED display Initial setup 1) 2) 3) 4) Select the module that will operate as the access point (AP) and set DIP switch 1 ON to enable AP operation. Plug in the access point. n — The LINK QUALITY LEDs will blink sequentially showing that the module is hunting for a subscriber unit (SU) to share keys — with. Plug in a subscriber unit. n — The LINK QUALITY LEDs will blink sequentially showing the module is hunting for an AP to supply a network key.
User’s Manual AW5800mT To add NEW subscriber units to the access point 1) Disconnect the AP from the network and disconnect power from the AP. 2) Connect an Ethernet cable from the AP to the SU (key exchange will not work through a switch or hub — crossover cables are not required). 3) Plug in the NEW SU, then plug in the AP. The units will automatically exchange keys over the Ethernet cable. 4) Repeat steps 2 and 3 until all SUs are successfully programmed.
AW5800mT User’s Manual Technical specifications CHARACTERISTIC SPECIFICATION / DESCRIPTION RF transmission rate Ethernet throughput Output power Receive sensitivity Radio link budget 1.
User’s Manual AW5800mT User’s Manual Requirements In order to inherit AvaLAN’s FCC Certification, compliance requires the following be stated in the user’s manual: FCC Notices Adherence to the following is required: IMPORTANT: The AW5800mT OEM RF Modules have been certified by the FCC for use with other products without any further certification (as per FCC section 2.1091). Changes or modifications not expressly approved by AvaLAN could void the user’s authority to operate the equipment.
To fulfill FCC certification requirements: 1. Integrator must ensure required text [Figure 1] is clearly placed on the outside of the final product. 2. This device has been designed to operate with the antenna types listed below, and having a maximum gain of 23 dB. 3. The required antenna impedance is 50 ohms. Table 1. Type certified antennae Antenna warning WARNING: This device has been tested with Reverse Polarity SMA connectors with the antennas listed in Table 1 Appendix A.
