Installation Guide

RECOMMENDED GROUNDING METHOD:

For your personal safety, this appliance must be grounded. It is equipped with a power supply cord having a

3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-

pronged wall socket, and grounded in accordance with the National Electrical Code and local codes and

ordinances. If a mating wall socket is not available, it is the personal responsibility of the customer to have a

properly grounded, 3-prong wall receptacle installed by a qualified electrician.

Before you move your beverage refrigerator into its final location, it is important to make sure you have the

proper electrical connection. A standard electrical supply (115 V, 60Hz), properly grounded in accordance

with the National Electrical Code and local codes and ordinances, is required. It is recommended that a

separate circuit, serving only your beverage refrigerator, be provided. Use receptacles that cannot be

turned off by a switch or pull chain. The fuse (or circuit breaker) size should be 15 Amps.

Installing Your Door Handle and Shelves

INSTALLING THE DOOR HANDLE:

1. Open the door and carefully pull the door gasket around the area where the handle is to be installed.

2. Insert each Phillips head screw through the gasket side of the door until the screw passes through the

door.

3. Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is flush

against the door frame.

Caution: Do not over-tighten the screws. This may cause damage to the handle or the door.

4. Carefully press the door gasket into its original position.

INSTALLING THE SHELVES:

1. Open the door completely.

2. Ensure that the metal guide posts are attached to the rear of the shelf.

3. Tilt the shelf 45° counterclockwise. The metal guide post on your left side should situate on the shelf

track.

4. Gently push the shelf back towards the rear of the unit until the right side metal guide post meets the

vertical indentation in the plastic interior cabinet.

5. Gently set the right side of the shelf down on the shelf track. The shelf should move forwards and

backwards smoothly.

Electrical Shock Hazard!

• Plug into a grounded 3-prong outlet.

• Never remove the grounding prong from the plug.

• Never use an adapter to bypass the grounding prong.

• DO NOT use an extension cord.

• Failure to follow these instructions can result in fire, electrical shock, or personal injury.