Use and Care Manual

5
Installation Clearance Requirements:
When installing the beverage refrigerator under a counter, follow the recommended spacing dimensions shown.
• To ensure proper service access and ventilation, allow between 1 - 2 inches of clearance at the back as shown in
the diagram.
• The installation should allow the unit to be pulled forward for servicing, if necessary.
• A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with National Electrical Code
and local codes and ordinances, is required.
LEVELING:
The beverage refrigerator should be installed on a firm and level surface that will be able to support the
entire weight of a fully loaded unit. It is important for the beverage refrigerator to be leveled in order to
work properly. It can be raised or lowered by rotating the plastic sheaths around each of the feet on the
bottom of the machine. If you find that the surface is not level, rotate the feet until the beverage
refrigerator becomes level. You may need to make several adjustments to level it. We recommend using a
carpenter’s level to check the machine. Turn the leveling feet to the right to lower that side of the
refrigerator. Turn the leveling feet to the left to raise that side of the refrigerator.
Important: Once you are ready to install the unit in a cabinet or directly on the floor, you must adjust the
feet to level the beverage refrigerator.